Five-Axis Machining Centers

Exploring the: Five-Axis Machining Centers Zone

18 Results for: Videos

Sort by:
Published: 4/5/2010

Video: 3+2 Mold Machining at Eifel
A maker of injection molds for high-appearance-quality parts describes the machine tool, software and strategy this shop uses to apply 3+2 machining.

Published: 3/17/2010

Mill’s Integral Rotary Axis Allows Turning
Video: Spanish machine tool builder Ibarmia offers a moving column machine that has an interesting table-within-a-table configuration.

Published: 2/18/2010

Video: High Speed Milling—900 ipm
Demonstation illustrates the kind of metal removal rate that is possible in aluminum at dynamically stable speeds.

Published: 8/18/2009

Improving Milling Accuracy
VIDEO. How you use the machining center is just as important as the quality of the machine itself. This tutorial covers machining center leveling, alignment and temperature—as well as toolchange and setup procedures.

Published: 2/4/2009

Video: Five-Axis Milling On Linear-Motor Machining Center
Linear motors take the place of ballscrews on this machine performing high speed cutting of aluminum at a job shop near Atlanta.

Published: 1/29/2009

Video: Horizontal Profiler For Aerospace Machining
An alternative to the typical profiler design, this machine saves labor by allowing chips to fall out of the way.

Published: 8/5/2008

Five-Axis Trimming Of Composites
Here is video of the five-axis motion required to trim a relatively simple composite component.

Published: 8/5/2008

Five-Axis Milling And Drilling Of Composite Component
This video from machine tool maker CMS shows high speed five-axis milling and drilling of composite component.