Aerospace Machining

Exploring the: Aerospace Machining Zone

36 Results for: Videos

Sort by:
Published: 8/15/2008

End Mill Comparisons in CFRP, Part 1 - Carbide Tool
Video shows the performance of coated carbide, diamond-coated, PCD and veined PCD tools in carbon fiber reinforced plastic. Part one in a four-part series.

Published: 8/14/2008

End Mill Comparisons in CFRP, Part 2 - Diamond-Coated Tool
Video shows the performance of coated carbide, diamond-coated, PCD and veined PCD tools in carbon fiber reinforced plastic. Part two in a four-part series.

Published: 8/13/2008

End Mill Comparisons in CFRP, Part 3 - Conventional PCD Tool
Video shows the performance of coated carbide, diamond-coated, PCD and veined PCD tools in carbon fiber reinforced plastic. Part three in a four-part series.

Published: 8/12/2008

End Mill Comparisons in CFRP, Part 4 - Veined PCD Tool
Video shows the performance of coated carbide, diamond-coated, PCD and veined PCD tools in carbon fiber reinforced plastic. Part four in a four-part series.

Published: 8/5/2008

Exit-Side Drill Penetration Without Delamination
Slow-motion video shows the effect of a micograin tool coating in drilling CFRP.

Published: 8/5/2008

Five-Axis Trimming Of Composites
Here is video of the five-axis motion required to trim a relatively simple composite component.