Cutting Tools

Exploring the: Cutting Tools Zone

45 Results for: Videos

Sort by:
Published: 9/11/2014

An Extreme Part-Off Demo Returns to IMTS 2014
The strength of part-off tools is shown in demonstrations whereby they part off a railroad rail and sledge hammer head. Talk about significant interrupted cuts…

Published: 2/4/2013

Video: Blisk Milling
The process seen here uses trochoidal tool paths and cryogenic cooling

Published: 10/24/2011

Video: Milling Inconel 718 with Cermic Inserts
Metal removal rate is high and the cut is dry. See other basic tips for milling with ceramics.

Published: 9/30/2011

Why Y?
This toolholder takes advantage of a Swiss-type’s Y-axis motion to approach and engage the barstock from the side, which helps prevent “bird nesting.”

Published: 8/5/2011

A Quick Way to Deburr Holes in Contoured Surfaces
This video shows a device that enables machine tools to quickly deburr both sides of through holes in elliptical and contoured surfaces.

Published: 5/16/2011

Dapra high feed cutting 4140ph at 300-ipm.
(sponsored content) Video: High-Feed Cutting 4140PH at 300 IPM with RHINO-FEED Mid-Feed Shell Mill and Inserts from Dapra.

Published: 4/18/2011

90-Degree Pocketing Aluminum - 0.250” DOC with Square Shoulder End Mill and XPET-ALU Inserts from Dapra
(sponsored content) This video demonstrates Dapra's 1" Square Shoulder End Mill executing a pocketing routine in aluminum.

Published: 4/11/2011

Video: Maximizing Cutter Life
A shop owner describes his simple approach to evaluating cutting tool performance and finding the best parameters.

Published: 2/11/2011

Video: Cryogenic Machining of Titanium
Through-tool liquid nitrogen turns the tool into a heat sink, extending tool life.

Published: 2/1/2011

Video: Safe Shrink-Fit Has Built-in Cooling
The cycle for heating the toolholder also includes water cooling so the toolholder finishes cool.

AMAMCO Tool exceeds ISO and AS 9100 standards for quality, precision, and consistency.
Click here>
ERIX tool saves up to 90% of the manufacturing time on back spotfacing and chamfering operations.