Milling Tools

Exploring the: Milling Tools Zone

33 Results for: Videos

Sort by:
Published: 3/11/2010

Video: Plunge Roughing in Aluminum
Even in aluminum, plunge roughing can be an effective way to realize high productivity.

Published: 3/11/2010

Video: High Feed Milling in Aluminum
Footage shows roughing at 48 cubic inch per minute on a standard-speed machining center.

Published: 2/12/2010

Video: Milling Inconel 718 Efficiently Without a Heavy Machine
This video of machining Inconel at a fast metal removal rate shows the effect of constant-engagement-angle milling.

Published: 2/12/2010

Video: Milling Titanium 6-4 Efficiently Without a Heavy Machine
This video of machining titanium at a fast metal removal rate shows the effect of constant-engagement-angle milling.

Published: 1/13/2010

Video: The Role of Heat in High Speed Machining
In high speed machining of die/mold steels, the heat has a more beneficial effect than the role it plays in conventional cuts.

Published: 12/9/2009

Video: Balancing Tools And Toolholders
This video provides both the argument and methodology for performing offline balancing of tool/toolholder assemblies for high speed machining centers.

Published: 7/28/2009

The Key Points Of Helical Holemaking
VIDEO. Have you considered milling holes through helical ramping instead of drilling them? This brief animated video covers the high points, including tool diameter selection and the potential for savings.

Published: 7/22/2009

Understanding Effective Diameter
VIDEO. On a ballnose end mill, the depth of cut determines the actual cutting diameter. This effect, along with the related concept of chip thinning, will influence the optimal choices of spindle speed and feed rate.

Published: 4/3/2009

Video: Faster Micro-Finishes for Micromachining
 Smooth finish comes from balanced cutting parameters, as this video explains.

Published: 2/6/2009

Video: Understanding The Role Of L:D Ratio In Micromachining
When milling with tiny tools, changing the length-to-diameter ratio can significantly change the cutting parameters it is possible to achieve.