Milling Tools

Exploring the: Milling Tools Zone

31 Results for: Videos

Sort by:
Published: 1/27/2009

Finishing Walls In Titanium
Machining animation from Boeing illustrates effective techniques for titanium workpieces. This video shows material machined out of the corners prior to finishing.

Published: 1/27/2009

Plunge-And-Sweep For Finishing Corners
Machining animation from Boeing illustrates effective techniques for titanium workpieces.

Published: 1/7/2009

Optimal Milling Strategy For Entering Material From The Side
These animations show why an arc in the same direction as tool rotation is effective. The strategy is relevant for entering material from the edge, as well as for pocketing.

Published: 1/7/2009

Video: 56-Percent Productivity Increase By Reducing Chatter
The video compares a milling pass that chatters to one that is stable. Because the stable speed permits greater depth of cut, productivity increases.

Published: 1/7/2009

Video: Finish-Milling Titanium With A 20-Flute End Mill
A tool with many flutes can be effective for achieving a productive metal removal rate in titanium, where speed and chip load are constrained. See how quickly the chips accumulate in this video.

Published: 8/22/2008

Video: Helical Interpolation Vs. Drilling
A machining center able to maintain precise control at high feed rates makes it practical to machine holes through helical milling as an alternative to drilling.

Published: 8/22/2008

Video: Micromilling With a Long Tool
This video clip illustrates micromilling at a high tool L:D ratio.

Published: 8/15/2008

End Mill Comparisons in CFRP, Part 1 - Carbide Tool
Video shows the performance of coated carbide, diamond-coated, PCD and veined PCD tools in carbon fiber reinforced plastic. Part one in a four-part series.

Published: 8/14/2008

End Mill Comparisons in CFRP, Part 2 - Diamond-Coated Tool
Video shows the performance of coated carbide, diamond-coated, PCD and veined PCD tools in carbon fiber reinforced plastic. Part two in a four-part series.

Published: 8/13/2008

End Mill Comparisons in CFRP, Part 3 - Conventional PCD Tool
Video shows the performance of coated carbide, diamond-coated, PCD and veined PCD tools in carbon fiber reinforced plastic. Part three in a four-part series.