Campro USA
Published

Getting into Gearing?

Gear designers and machine programmers/operators alike will benefit by attending this training course, where they will gain an understanding of gear noise dynamics.

Share

Are you a machine shop that is considering getting into gear manufacturing as a new revenue stream, or has already purchased the necessary equipment to do so and wants to learn more? If so, Gear Production—the quarterly supplement to Modern Machine Shop—is for you. And you’ll also want to know about a valuable training opportunity that’s coming up soon. For nearly four decades engineers, technicians and others have gained an understanding of the mechanisms of gear noise generation, measurement and reduction by attending the Gear Dynamics and Gear Noise Short Course at The Ohio State University (OSU).

Beginning with the fundamentals of gearing, gear dynamics, noise analysis and measurements, the four-day course blends lectures with demonstrations, all powered by data compiled by OSU’s Gear and Power Transmission Research Laboratory. Attendees will learn why gears make noise, how the source can be identified, and methods for addressing gear noise challenges. Lecturers will also concentrate on gear system dynamics and acoustics, transmission error calculations and advanced signal processing. Real-world case studies will be presented, along with laboratory demonstrations and problem-solving exercises.

The course organizers are Dr. Donald Houser, professor emeritus of mechanical engineering at OSU and founder of the Gear Dynamics and Gear Noise Research Laboratory, and Dr. Rajendra Singh, director of the university’s Acoustics and Dynamics Laboratory. All gear manufacturers will benefit from attending, but especially those targeting automotive, aerospace, process machinery and wind energy markets. The event will be held September 28 through October 1, 2015, on the OSU campus in Columbus, Ohio. Learn more by visiting nvhgear.org.

Campro USA
SW North America, CNC Machines and Automation
YCM Alliance
SolidCAM
DN Solutions
MMS Made in the USA
TIMTOS
JTEKT
SW North America, CNC Machines and Automation